C2829 BMW Fault Code

Description:

The Transmission Range Sensor (also referred to as the PRNDL input an/or neutral safety switch) tells the transmission control module (TCM) an the engine control module (PCM) that the transmission is in park, reverse, neutral, drive, low, 2nd, 3rd etc. It is attached directly to the manual valve of transmission, so when the shift lever is moved from park to drive, the Transmission Range Sensor communicates this critical information to the above mentioned vehicle control module systems.

C2829 Code Symptoms :

While fuel economy was increased, acceleration was seriously compromised, and the loss of engine vacuum led to a dangerous loss of braking assist when the C2829 code system was in four-cylinder mode. In addition to these issues, while the company proposed a hydraulically controlled system that could be switched from within the car, the version they implemented had to be manually changed in the engine compartment using hand tools.

Diagnosis And Repairing C2829

Parts or components should not be replaced with reference to only a C2829 DTC. The vehicle service manual should be consulted for more information on possible causes of the fault, along with required testing.

How to fix C2829 code ?

• Engine Control Module (ECM)
• Damaged VCT phaser
• Faulty Variable Camshaft Timing (VCT) position solenoid
• Insufficient cylinders compression

A good starting point in your diagnosis is checking all system fuses and fusible links. This can be done using the BMW DVOM on the voltage setting. You will want to test the fuses with circuits loaded.

Some fuses will appear normal until a load is placed on their respective circuit; at which point they will fail. This has been the cause of many 'phantom malfunctions'. Consult your vehicle information source for fuse and fusible link locations. If all fuses are in working order, you may want to check TCM relay operation by swapping identical relays. Usually the horn relay, starter relay, fuel pump relay, air conditioning clutch relay, and controller relays are similar enough in design to swap for diagnostic purposes.